Car Parts Discount
Clutch Release Bearing

Aftermarket & OEM Clutch Release Bearing

Your manual transmission would not function properly without a working and intact clutch release bearing. If you "ride the clutch" rather than downshifting or dropping into neutral, then it will be engaged way too often. This over exerts the components of the clutch, and causes premature wear and failure. A common symptom of a busted or broken throw-out bearing is a loud squealing when the clutch pedal is depressed. This comes from miles and miles of unnecessary use, when all it was intended for was a momentary engagement and disengagement of the clutch disc and pressure plate. When it is broken, it will also adversely affect the diaphragm springs in the pressure plate causing that terrible sound you are likely hearing. Shifts will also become difficult and eventually impossible for the driver; ultimately rendering the car useless until it is fixed. Most clutch service includes replacement of the clutch release bearing as a preventative measure. This is always recommended, however it is sometimes necessary to fix this problem in some cases when a failed bearing is all that's broken.

A quick look at your manual transmission will show you the location of your clutch release bearing. It is always connected to a fork that moves it back and forth when the clutch pedal is pressed. Sometimes that fork is actuated by a hydraulic slave cylinder, and sometimes it is actuated by a cable. Either way, simply follow the cable or hose down to where the bell housing meets the transmission, and there you will find the throw-out bearing. The presence of this bearing is what makes it at all possible for the rotation of the flywheel to separate from the rotation of the transmission input shaft so that a gear shift can take place.

Working on your transmission can sometimes be a laborious task. Every engine is different, so the steps taken to undergo the installation of a clutch release bearing will vary from vehicle to vehicle. The basic steps are simple, however.
  • First, disconnect any hoses, wire harnesses, and mounting hardware that will prevent you from either lifting the engine or dropping the transmission.
  • Once that is done, you can expose the clutch pressure plate as well as the transmission input shaft. Around that shaft you will see the release fork holding the throw-out bearing.
  • Remove the fork from its pivot point. You can now simply slide out the bearing.
  • When you put in the new one, make sure that the fork spring tabs are under the top flange of the bearing. That is crucial.
  • Finally, re-install all the components you removed in reverse order.

A full day of work, some patience, and a lot of elbow grease will solve most any car problems. Fixing a worn out clutch release bearing is no different. At Car Parts Discount, we understand the need for quality parts at low prices. That's why we carry top name brands from aftermarket manufacturers as well as original equipment from genuine sources. CPD makes throw-out bearing replacement easy and affordable with quick shipping options, hassle-free warranties, and knowledgeable customer service. Don't delay, buy your parts today.