Car Parts Discount
Hood Release Cable

Aftermarket & OEM Hood Release Cable

So you've been pulling on your hood release handle, and the hood doesn't pop; leading you to believe that the release cable is broken. You are probably right, considering there are few moving parts to this mechanism. Unfortunately, without a properly working hood release cable, your hood latch won't pop the hood as easily as you would want it to. Of course, there is a way to open the hood using hand tools from underneath, and you will eventually have to do that to replace the cable. But imagine how tiring and frustrating that is going to be if you have to jump start your car, change a headlight bulb, top off your oil, change your air filter, check your belts, etc. Clearly, a functioning hood release cable is more than just a simple convenience... it is a virtual necessity.

In the late 19th century, an Irish inventor named Ernest Monnington Bowden invented a type of cable that could transmit pulling, pushing, or twisting motions from a user in order to actuate a mechanical device. It consists of a braided or woven steel wire inside a rubber tube; at one end attached to some sort of handle, trigger, or toggle, and at the other attached to an actuator for the device to be controlled. In the case of a hood release cable, one end is attached to the release handle underneath the dashboard or steering column. Before the cable housing passes through the firewall, it is attached to a fixed point so that it will not move. This means that when the handle is pulled, only the steel cable inside the sheath moves. At the other end the cable is attached to the hood latch via a ball, loop, or fork. Again, the housing tube is clipped to several body pieces so it does not move as the hood release cable is pulled.

Replacing your hood release cable isn't difficult, but requires the removal of some body pieces in order to accomplish the task. Every car and truck is different, so the procedure cannot be applied to all vehicles. But here are the simple steps:
  • First, remove any clips or hardware that prevent access to the hood latch. Sometimes this may mean removing the entire front grille or bumper cover.
  • Next, unbolt the hood latch from the radiator core support or hood latch panel. Pry the cable connector away from the latch.
  • Now, pop the clips that are holding the cable in place as you move from the front of the car, through the engine bay, all the way to the firewall.
  • Then, disconnect the cable from the back of the handle under the dash. In some cars, the handle and cable are an entire assembly so you may have to remove the entire unit.
  • Finally, re-install all components in reverse. Remember to make sure the new hood latch release cable follows the exact same path as the previous one did.

You can't go forever driving around without an operating hood latch. That's why replacing your hood latch cable is so important. At Car Parts Discount, we offer quality replacement hood latch cables from aftermarket manufacturers as well as a few from the genuine original supplier. With our selection, we can get you great prices, fast shipping, and the piece of mind that the part you are buying is going to fit and perform perfectly the first time.